if some of u have read my mom crashed my ranger into a ditch well i was in D.C. and no one told me about it till i got home. so now i am forced to fix all that and i figured well i am doing that i will build afew more things up on it. well i am adding 3 inch blocks in the rear and cranking the torsion bars up front untill i get enough to do it right. and i'm going to add new skid plates ones that are thicker. and i'm going to build and weld a new rear and front bumper and also add aux lights. pics will be up as soon as i can find where my camera is "my mom cleaned my ROOM as well ugh" >:? >:?
wel i might as well start my own build thread
1 - 20 of 106 Posts
Joined
·
1,936 Posts
8) I can't wait to see this build thread.
Joined
·
1,340 Posts
^^^
Joined
·
1,936 Posts
I think ^^^ that means he agrees with the post before or above him how ever you look at it
Joined
·
1,340 Posts
Yupgerald1488 said:
well i opend the hood of the demon and i find out it's bleeding red blood all over the engine and ground so i searched around and i now found out the tranny line blew up ALL over the place so i have a new question that noise i said sounded like it was from the rear end in the tranny fluid was slowly leaking out of a line and is low in the tranny could the tranny make the noise if there is low to no fluid in it?
Joined
·
1,936 Posts
Yes it can your going to need to replace that line and fill the transmission back up with fluid... And hope like hell there is no damage to the transmission
Joined
·
1,936 Posts
You know it would be easier to call them that way you can get an exact amount because here in SD it might be more or less it depends on where you go.
Joined
·
1,936 Posts
yes there is a good possibility. you might get a bad one or you might get a good one...
i'm so fucking pissed off he has been driving it for a month WITHOUT ANY TRANNY FLUID i just went out side and checked the fluid level and it aint got any that is what the noise is ugggggggggh i am so mad at both my damn parents wtf am i going to do now i need a new tranny as well as wheel bearing, sway bar, new hub, new a-arm, tranny hose, all the hardware for all this, and new brake hose to the caliper which i found out is where all the brake fluid went ugh i'm going to have to sell my focus to do all this. idk what to do with it or where to start anymoreok well i just came back in i put fluid in it and i put some brake fluid in it too and i turned it on and put it in reverse and it went back than i tried to put it in drive and guess what it wouldn't go into reverse for a few secs i had to rev the engine to get it to lock into drive so what does that mean? i sure wish plum was on here when i could use his expertness
1 - 20 of 106 Posts
