wow that is beefy for sho lol. for the d35 dyll all you have to do is cut a piece that will bolt to the holes around the cover. just take a look at sloues diff
Since the TTB d35 uses the beam for the cover it is thick enough. The week point on the TTB d35 is the aluminum housing, something comes up under the housing it will rip it off the beam. The best thing to make for it is a skid plate that goes from the bottom holes on the diff to a clamp around the yoke.
I havent built mine yet but I start my winter break on Wednesday so I will get to work on it soon. Plan to make it out of 1/4 plate. I hate being 2 hrs from my shop with all my tools and welder.
Hello,
I was doing some work that required removing the glovebox and lost the two clips that attach the cylinder damper and the strap to the glovebox. These are the clips that slide over the little brass pegs on both side of the glove box where the cylinder (#3) and straps (#10) attach...
hey, im looking at some paint options for my B2
id like from the top body line (door handle line) down to the bottom of her in black, and the top just left the original blue thats on her. and another copy with the same black, only i would like the blue done like a darker blue, but not quite...
Been working on these for Andrew (bigandrw on r-f) for a while now. Got the main seats finished today. Still need to button up the leg extender piece. These are late 80s reg cab Ranger GT buckets. Pretty much the same as the Mustang GT seats, minus the headrests. Black vinyl with black suede...
