Ford Ranger Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I just bought a 1999 Ford Ranger 4X4, and was reading the forums on cruise control installations. Mine didn't have cruise and I like to use it so I went to pick a part and found a 01 Ranger with the engine gone but it had cruise control still intact. I removed the buttons, cables and clockspring and cable, and also noticed the servo which was still mounted to the fender. I removed it and ordered a new crusise control servo cable. I have everything installed but then on one of the forums that outlined the procedures I noticed it said to install master cylinder with pedal pressure switch and connect wiring or jumper the two wires together with a 2 amp fuse. I took a picture of my master cylinder and it doesnot have the pedal pressure switch. So I am curious what I have to do to make everything work?? SAM_1189a.jpg
 
1 - 1 of 1 Posts
Top