Joined
·
1 Posts
Hi everyone! I could use some help identifying a hose under the hood. I attached a picture that I have noted of what hose I'm trying to identifying. Thanks for all the help in advance.
Identifying motor hose help
Join the discussion
Recommended Reading
-
Need input on turning but not starting engine
6 Cylinder EnginesHello! 2010 V6 4.0L. I was going 65 on the highway and the engine just stopped. When I plugged the ODBII it gave me 3 codes P0351, P0352 and P0353. So I changed the coil pack and the engine still turns but doesn't start. So I changed the Crank position sensor. Still won't start. And now I...- 0
- 29
-
DV8 · updated
-
I need more power!
6 Cylinder EnginesI drive an 86 ranger, 2.9 V6 manual. Its a good truck it just does not have power in my higher gears like 4th and 5th. My lower gears are strong and get up to about 40 to 45 mph just fine but when I put it into 4th to reach up to about 60 it just barely gets there. 5th gear practically does...- 1
- 82
-
2003 Ranger 3.0L flex fuel engine block cylinder numbers
6 Cylinder EnginesI'm currently looking for anyone who can give an accurate diagram of the cylinder numbers on the engine and coil pack. Trying to run wires due to multiple misfires and haven't found an accurate true diagram for the true cylinder numbers on each bank or the engine. Thanks.- 0
- 95
-
Help!!
6 Cylinder EnginesHey, I just recently got a 2000 ford ranger xlt. The older guy I got the truck from said the spark plugs kept going out but had them recently replaced so it ran with no problems. But now I have a check engine light on about a bad spark plug. Just wondering what causes spark plugs to go bad so...- 1
- 64
-
BadRanger · updated
-
corrosion around spark plug
6 Cylinder Enginescannot get socket on the plug any suggestions- 0
- 98
-
wayne · updated
Join now to ask and comment!