Ford Ranger Forums banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
179 Posts
Discussion Starter #1
I have a Detroit locker to fit Dana 44 axles. Front or rear any brand as long as it's a 30 spline axle. It is part number 187SL16D. This was installed, driven around the parking lot and taken back out as the gears were not correct for 35" tires. Cost me a touch over $600CAD a year ago. Need it gone. $420CAD (397USD) + Shipping and it's yours. That's 1/3 off what I paid for it. Still have the manufacturers documentation that came with it.
Email me at: [email protected]
 

·
Premium Member
Joined
·
3,321 Posts
Are there certain gears that it will not fit?

I'm going to probably have 36's or 37's on my 97 Ranger and gonna go with 5.13 gears or 4.56 gears (with V8 swap). Would it still work?

Thanks!
 

·
Registered
Joined
·
3,686 Posts
you will have to charge alot for shipping to make any money back on it
 

·
Registered
Joined
·
179 Posts
Discussion Starter #6
I'm not gonna overcharge on shipping. I have no doubt I'm gonna lose out on this... A lot. But some money back is better than none.
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top